» Connector Built-in U-shaped Micro Photoelectric Se

Easy connection with a single touch using commercially-available connectors.

※1

※2

※1	Conforming to EMC Directive
※2	Recognition

Features

Built-in connector saves space

This greatly reduces the amount of space taken up compared to previous models.
The dimension between the beam axis and cable bending part has been reduced to half at maximum.

Can be connected using commercially-available connectors

The connector connection type eliminates the extra work of soldering and insulation processing. In addition, the connector used is a commercially-available multipurpose connector which is also currently used by the DP-100 series of digital pressure sensors.

Improved maintenance and workability significantly reduces total cost

The processing cost of the connector cables can be drastically reduced through the use of commercially-available crimping connectors.

Previous model (Soldering: Connector type)

Automation is hard because of soldering.
Insulation processing is required.
A large space is necessary at the terminal area.
Connectors are not reliable
(not fully connected or seated).

Previous model (Converted to the cable-type commercially-available connector)

Crimping processing is required in two places.
A set of commercially-available connectors is necessary.
There are many processes for cable connections.
An intermediate box is required.

PM-64 series (Commercially-available connectors can be used)

Crimping processing makes automation possible so the connectors are also highly reliable.
Soldering, insulation processing, and an intermediate box are not necessary.
Connectors are widely available.
Mounting in a small space is easy.
Strongly connected using a locking connector.
1 m 3.281 ft, 2 m 6.562 ft, 3 m 9.843 ft, and 5 m16.404 ft connector cables are available.